FASTTRACK Knife Sharpener – Instructions download

 

 

SAFETY

Before attempting to use the FTS KS, please understand that handling knives can be dangerous.

Users must be competent in handling knives safely and understand safe sharpening practices before using this product.

 

KNIFE GRIP

MPOWER Knife Sharpener Diamond Knife_Grip

Always hold knife in your dominant hand with a light grip.

 

IMPORTANT

MPOWER Knife Sharpener Diamond Worktop_Technique

The flat of the blade must remain against the front strop during stroke. The Magnets will help with this.

DO NOT allow blade to come away as it will drop into the slot.

 

WORKTOP TECHNIQUE – Master this technique first

MPOWER Knife Sharpener Diamond Worktop_Technique

Resting the KS on a worktop, hold top of handle with your non dominant hand. Hold knife loosely take 4 sharpening strokes.

MPOWER Knife Sharpener Diamond Worktop_Technique

Rotate Knife Sharpener 180 degrees, slot facing in the opposite direction.

MPOWER Knife Sharpener Diamond Worktop_Technique

Repeat same number of full strokes. When edge is achieved, see Strop Technique.

 

EXPLODED DIAGRAM

MPOWER Knife Sharpener Diamond Worktop_Technique

 

FREE HAND TECHNIQUE

MPOWER Knife Sharpener Diamond Free_Hand_Technique

Hold the knife Sharpener in your non-dominant hand. Insert the Knife.

MPOWER Knife Sharpener Diamond Free_Hand_Technique

Take 4 sharpening strokes the full length of the blade in the direction of the arrow.

MPOWER Knife Sharpener Diamond Free_Hand_Technique

Rotate the KS over so that the slot faces down.

MPOWER Knife Sharpener Diamond Free_Hand_Technique

Repeat same number of full sharpening strokes.

Note: Always repeat the same number of strokes per side of knife.

 

STROPPING TECHNIQUE

When sharp edge is achieved; rotate Knife Sharpener leather strop face up and wipe blade edge across strop.

Turn Knife over and to wipe both sides of edge across leather strop.

 

REMOVING DIAMOND STONES

Holding the ends of the diamond stone, unclip it from the front plate magnet.

Slide the Diamond Stone up or out of the side.

NOTE

Depending on how damaged the knife is. It may take 5-10 minutes work to regrind and establish new bevels to the blade edge. Afterwards it will only take 3 or 4 strokes on both sides to refresh the edge.

MAINTENANCE

Store in dry clean environment, wipe occasionally with a damp cloth.

Not Dishwasher friendly.

Cleaning Diamond stones – Use a pencil eraser to gently rub the Diamond surface clean.

POLICY

Our continuous improvement means that specifications may change without notice. M.POWER Tools Limited cannot be held liable for any material rendered unusable, or for any form of consequential loss.

GUARANTEE

All MPOWER products are guaranteed against any defects in either workmanship or material, except products that have been damaged due to improper use or maintenance.